MS-Pcman
03-06-04, 01:45 PM
On the IC7-MAX3
Does anyone know what the "I" and "II" wires on the wire harness go to ? (the harness that also has the Pwr-On & Reset)
And, is it true that it doesn't mater how you orientate - plug the Pwr-On & RST as relating to polarity (POS or GRND) ?
Done boards before, but not an ABIT that's not labeled well.
Do you need to load anything from the CD, or make any significant changes to CMOS before booting ? Or is the standard basic setup enough that it will boot correctly ? Or do you need to clear CMOS like they imply ?
The PwrSupply (Antec SOHO 1040B2 has 3 Power Leads to the motherboard (IC7-MAX3). Do you plug all 3 in ? Or just 1 of the 3 ? The ANTEC SOHO 1040B2 (400w) has the standard 20 pin plug the 4 pin plug (12v) and the 6 pin AUX plug. Is this a case of use 1 of the 3, or are they used together for different Functions ?
New to this Forum, but not new to PCs, behind on P4's
Thanks
Does anyone know what the "I" and "II" wires on the wire harness go to ? (the harness that also has the Pwr-On & Reset)
And, is it true that it doesn't mater how you orientate - plug the Pwr-On & RST as relating to polarity (POS or GRND) ?
Done boards before, but not an ABIT that's not labeled well.
Do you need to load anything from the CD, or make any significant changes to CMOS before booting ? Or is the standard basic setup enough that it will boot correctly ? Or do you need to clear CMOS like they imply ?
The PwrSupply (Antec SOHO 1040B2 has 3 Power Leads to the motherboard (IC7-MAX3). Do you plug all 3 in ? Or just 1 of the 3 ? The ANTEC SOHO 1040B2 (400w) has the standard 20 pin plug the 4 pin plug (12v) and the 6 pin AUX plug. Is this a case of use 1 of the 3, or are they used together for different Functions ?
New to this Forum, but not new to PCs, behind on P4's
Thanks